ConnectorFlags (GVL)¶

Connector flags: Flags that specifies diagnostic informations of a connector

InOut:

Scope	Name	Type	Initial	Comment
Constant	CF_ENABLE	`WORD`	16#1	Connector enabled
	CF_DIAG_PROVIDER	`WORD`	16#2	Connector provides diagnosis for the associated device.
	CF_DEVICE_ENABLED	`WORD`	16#4	Only valid if CF_DIAG_PROVIDER is set. Specifies if device is currently enabled (used by Reconfigure).
	CF_DEMOLICENSE_ACTIVE	`WORD`	16#8	Demo License is active
	CF_DRIVER_AVAILABLE	`WORD`	16#10	A driver is available
	CF_CONNECTOR_FOUND	`WORD`	16#20	Connector found (device detected)
	CF_CONNECTOR_CONFIGURED	`WORD`	16#40	Connector configured
	CF_CONNECTOR_ACTIVE	`WORD`	16#80	Connector active
	CF_CONNECTOR_BUS_ERROR	`WORD`	16#100	Bus error
	CF_CONNECTOR_ERROR	`WORD`	16#200	General connector error
	CF_CONNECTOR_DIAGNOSTIC_AVAILABLE	`WORD`	16#400	Diagnostic information available
	CF_CONNECTOR_PASSIVE	`WORD`	16#800	Passive mode of the second master in redundancy systems
	CF_ERROR_CLEARED	`WORD`	16#1000	An Error was automatically cleared by the driver